Call Dropped after failover (BSS)

[o.mahmoud]

1. Brekeke Product Name and Version:
Brekeke SIP Server, Version 3.8.2.4, Advanced

2. Java version:
1.8.0_171

3. OS type and the version:
Windows Server 2012 R2 / 6.3 / amd64

4. UA (phone), gateway or other hardware/software involved:
YEALINK T40G IP PHONE
DIALOGIC MEDIA GATEWAY

5. Your problem:
I configured the Redundancy for the BSS as mentionned on the Brekeke Wiki and documentation.
When I tested the Brekeke SIP Server redundancy by unpluging primary server ethernet cable the failover is done and the call remains connected. But, when we make failover happen by shut down primary server or stop primary Brekeke SIP server from admintool, the call is dropped. I see that a BYE was sent by the VIRTUAL IP ADDRESS to the UAs.

Is this the normal behaviour of the BSS redundancy or there is any other config to setup for heartbeat (other that the ones mentionned on the wiki and the doc).

Regards,

[Harold]

It is what they designed.