Incoming DTMF not recognized

juanmanuel · Post by **juanmanuel** » Thu Mar 17, 2011 2:52 pm

1. Brekeke Product Name and version: PBX Version 2.4.7.3

2. Java version:

3. OS type and the version:

4. UA (phone), gateway or other hardware/software involved:

5. Select your network pattern from http://www.brekeke-sip.com/bbs/network/ ... terns.html :

6. Your problem:

When PbX receives a call from a registered UA the DTMF sent are recognized by the AA, in this case the call is answered by AA and redirected to extension dialed by DTMF
But when it receives a call from one non registered UA, the DTMF are not recognized, in this case the call is answered by AA but not redirected to extension dialed by DTMF

The diference I see is that the INVITE from registered UA includes NOTIFY but the INVITE from non registered does not.

Dose this diference cause the problem?

Thanks and Best Regards

hope · Post by **hope** » Fri Mar 18, 2011 2:47 pm

what type DTMF used by caller?
what codecs used for the call?
how about change caller DTMF as SIP INFO?
have you set [RFC2833] on at pbx/options?

juanmanuel · Post by **juanmanuel** » Fri Mar 18, 2011 3:04 pm

Thanks for your answer

DTMF using RFC2833 at PBX as well at UA, codec G711 mu law

I have change to SIP-INFO and the result is the same.

I see at Sniffer that after the UA send the DTMF using RTP EVE, Brekeke PBX does noy send any confirmation for recieve it, as does when the UA is registered.