Is it possible to route between 2 ITSP?

hoanguyen · Post by **hoanguyen** » Tue May 22, 2007 3:03 pm

1. Brekeke Product Name and version:

2. Java version:

3. OS type and the version:Version 1.5.3.0

4. UA (phone), gateway or other hardware/software involved: SPA-3000 with dynamic IP and using dyndns.org for solution.

5. Select your network pattern from http://www.brekeke-sip.com/bbs/network/ ... terns.html :

6. Your problem:
I have 2 ITSP with 2 inbound numbers, the call out is limit 1 call per outbound by ITSP.
Is it possible to have dial plan that check if the first one is in-use then change the route to second one?

Something like:

Matching patterns:
$request=^INVITE
To=(.*\.broadvoice\.com)
$port=15062
&& if inuse then

Deploy Patterns:[/u]$
auth=off
$target=the second ITSP address.

Thks.

hoanguyen · Post by **hoanguyen** » Wed May 23, 2007 12:27 pm

Anyone know this?

voipwell.com · Post by **voipwell.com** » Fri May 25, 2007 4:40 pm

Hi,

That's a pbx feature. Hey, Brekeke needs to make a living some how.

hoanguyen · Post by **hoanguyen** » Mon May 28, 2007 10:14 pm

Hey,I got PBX ver 1.5.3.0 (small office) and it doesn't come with that feature.

voipwell.com · Post by **voipwell.com** » Tue May 29, 2007 11:28 am

hoanguyen,

Sure it does come with that feature.

If you look at your ARS out section you will see two fields, Priorities and max sessions. Set your priority for the two itsp's. Broadvoice 1 and other isp 2. Then change max sessions from -1 which means unlimited to 1 which means 1 and if BV is busy it will send the call out to the other isp.

Nick