Connectting Brekeke PBX to A Session Boarder Controller

rsmithidgc · Post by **rsmithidgc** » Tue Mar 22, 2016 7:41 am

1. Brekeke Product Name and Version:Brekeke PBX, Version 3.5.3.3

2. Java version:

3. OS type and the version:Windows server 2012

4. UA (phone), gateway or other hardware/software involved: Blox SBC

5. Your problem: i am having trouble getting brekeke to send and receive calls from and to the sbc.

Tata · Post by **Tata** » Tue Mar 22, 2016 9:15 am

Do you still have the problem if you don't use the SBC?

rsmithidgc · Post by **rsmithidgc** » Mon Mar 28, 2016 7:44 am

sorry for the log delay i had to out of town for business.
i have gotten the sbc to register ext to pbx and make calls. now i need to get the brekeke to accept incoming calls from ITSP trough the sbc and Send calls to ITSP though the sbc. how can i do that using ars and dial plan

janP · Post by **janP** » Mon Mar 28, 2016 9:51 am

Have you tried Brekeke PBX without the SBC?

rsmithidgc · Post by **rsmithidgc** » Mon Mar 28, 2016 10:40 am

yes

i can setup to work with out the SBC but i would like to have it in line.

janP · Post by **janP** » Mon Mar 28, 2016 12:07 pm

Does the SBC work as outbound proxy? so do you need to specify SBC's IP address as SIP destination?

rsmithidgc · Post by **rsmithidgc** » Mon Mar 28, 2016 12:55 pm

yes it dose kinda.
i am useing Blox SBC

janP · Post by **janP** » Mon Mar 28, 2016 1:15 pm

Have you made ARS for connecting to the ITSP ? Does it work without the SBC?

rsmithidgc · Post by **rsmithidgc** » Tue Mar 29, 2016 1:48 pm

that is where i am now stuck is gettinng the ars config

janP · Post by **janP** » Tue Mar 29, 2016 4:12 pm

Have you looked at this wiki page?
http://wiki.brekeke.com/wiki/Setup-for-Connecting-ITSP

rsmithidgc · Post by **rsmithidgc** » Wed Mar 30, 2016 7:00 am

thank you janp i have looked at the wiki page
what i need is for the brekeke to accecpt calls comming from 123.23.1.1 with out auth then to send calls to same address when 9 is dialed

janP · Post by **janP** » Wed Mar 30, 2016 11:04 am

For disabling the auth if an INVITE is sent from 123.23.1.1, add this DialPlan rule in the top of the DialPlan page.
[Matching Patterns]
$request = ^INVITE
$addr = 123.23.1.1$

[Deploy Pattern]
$auth = off
$continue = true

For sending a call to 123.23.1.1 when 9 is dialed, add ARS route in the PBX.

rsmithidgc · Post by **rsmithidgc** » Wed Mar 30, 2016 12:45 pm

thank you
the problem was resolved with the help of the itsp.

janP · Post by **janP** » Wed Mar 30, 2016 3:43 pm

great!