Brekeke + Sangoma NetBorder Express

derekb · Post by **derekb** » Thu Dec 02, 2010 6:50 am

1. Brekeke Product Name and version: Brekeke SIP Server 2.4.7.3/286.1

2. Java version:

3. OS type and the version: Windows Server 2008R2

4. UA (phone), gateway or other hardware/software involved: Sangoma NetBorder Express (T1 Interface)

5. Select your network pattern from http://www.brekeke-sip.com/bbs/network/ ... terns.html : Pattern 2

6. Your problem:

We currently have a Brekeke SIP Server (192.168.10.101) and Brekeke PBX (192.168.10.102) setup with a fresh installation of the software. We have a Sangoma NetBorder Express SIP Gateway that we are trying to use to terminate our calls. This is at 192.168.10.103.

We can see calls being sent to the Sangoma Gateway, but the Brekeke side is sending a 'BYE' and not allowing the call to go through.

For example, if I setup a SIP Phone at my desk and call a local telephone number, I can hear the call ringing but it simply rings forever instead of an auto-attendant answering on the other end.

If there is anything you need from me (WireShark captures, call log files, etc) please let me know and I will be happy to reply.

hope · Post by **hope** » Thu Dec 02, 2010 12:24 pm

http://wiki.brekeke.com/wiki/Sangoma-Ne ... ss-Gateway

derekb · Post by **derekb** » Thu Dec 02, 2010 12:31 pm

I've actually gotten calling to work at this point and have established 2-way audio, but I had to disable RTP Relay in Brekeke PBX.

I'm having a problem where the call drops after approximately 3 minutes.

hope · Post by **hope** » Thu Dec 02, 2010 4:23 pm

do you mean if set pbx rtp relay on, call drop in 3 minutes?
is there session timer used for the call?
http://wiki.brekeke.com/wiki/disconnect-suddenly