connect to sip provider

pel-ee · Post by **pel-ee** » Thu Jan 22, 2009 12:59 pm

1. Brekeke Product Name and version:
Brekeke PBX 2.2.6.2

2. Java version:

3. OS type and the version:

4. UA (phone), gateway or other hardware/software involved:

5. Select your network pattern from http://www.brekeke-sip.com/bbs/network/ ... terns.html : Pattern 8

6. Your problem:

Hello!
We have a problem.
I'm trying to connect with sip provider. I prescribed the port forwarding on the NAT for sip and rtp traffic, as write in the instructions "How to set port forwarding?"
I have a problem, when I change ip address in the field of PBX SIP Server> Config> System> Network Interface Address on global ip our router.
When I restart pbx, phones have been registered in the pbx among themselves do not want to call (error 486 - busy here)
I use the trial version, it may be the cause of this problem?
If not, how could you help to solve this problem?
Thanks

taitan · Post by **taitan** » Thu Jan 22, 2009 8:12 pm

Which OS are you using?
Which IP address can you see in the "Interface" field on the front page?

pel-ee · Post by **pel-ee** » Fri Jan 23, 2009 2:08 am

taitan wrote:Which OS are you using?
Which IP address can you see in the "Interface" field on the front page?

I use OS Ubuntu 8.10
In the field "Interface", I see a global ip address of the router.

small correction, the error is not 486. Error is 483 (Too Many Hops)

taitan · Post by **taitan** » Fri Jan 23, 2009 11:23 am

It seems /etc/hosts doesn't have "localhost" information..
You need to edit /etc/hosts correctly..

OR, Add your computer's IP address in the Serrver's Interface settings (e.g. as "Interface address 2").