dial plan from pbxnsip server

[jst9943]

1. Brekeke Product Name and version: 2.2.1.6

2. Java version: version 4

3. OS type and the version: windows server 2003

4. UA (phone), gateway or other hardware/software involved: softphone , ip pabx

5. Select your network pattern from http://www.brekeke-sip.com/bbs/network/ ... terns.html :

6. Your problem: I would like to setup calls from ip pabx server, pbxnsip to ua in the sip server. How can I set the dial plan to call ua in the sip server. I have set the following

matching pattern

$request = ^invite
$registered=false
$addr=146\.82\.219\.20

deploy pattern

TO= sip:3%1@

The deploy pattern is for all ua in the sipserver. Am I doing the dialplan correctly? where I want that calls from a non registered ua in the pbx to ua registered in the sipserver. Using this dial plan I get a 407 error on my call log.

[hope]

Does the dialplan miss something?

matching pattern
$request = ^INVITE
$registered=false
$addr=146\.82\.219\.20
To=sip:(.+)@

deploy pattern

To= sip:3%1@

Using this dial plan I get a 407 error on my call log.

is the Authentication Invite set ON at Sip Server?
Turn authentication off or set User Authentication

[jst9943]

Did the changes but still did not work. What I would like to accomplished is to have a dial plan on the sip server that will accept an incoming call from another server that is not registered. In this dialplan, once the sipserver received a call from the other server it will route the call to the ua in the sip server based on the number sent by the other server.

[lakeview]

Hi jst9943,

If a UA in the SIP Server is registered, you don't have to use any DialPlan rules.
So delete the DialPlan and try to make a call from pbxnsip .

I wonder.. why do you want to use pbxnsip?

[jst9943]

Hi jst9943,

If a UA in the SIP Server is registered, you don't have to use any DialPlan rules.
So delete the DialPlan and try to make a call from pbxnsip .

I wonder.. why do you want to use pbxnsip?

HI, thank you for your reply. I would like to have user in pbxnsip to call user in the brekeke sip server and vise versa. Right now, I can have brekeke user call any ua that is register in pbxnsip but ua from pbxnsip to brekeke ua gets a 407 error.

[lakeview]

>> gets a 407 error.

This is because you are using the INVITE-Authentication in Brekeke..

Use "$auth=off" in the DialPlan.
----------------------------------
[Matching Pattern]
$request = ^INVITE
$addr = 146\.82\.219\.20

[Deploy Pattern]
$auth = off
$continue = true
----------------------------------