Port problem for registration with Brekeke PBX

Javedcse · Post by **Javedcse** » Thu Jul 24, 2008 9:51 pm

Dear All
I want to register a user suppose '101' with Brekeke PBX using sip port 1079 and then Brekeke PBX will register the user with another sip server which is using sip port 5060.

How can i do that?

Note:
when i use 5060 sip port in Brekeke PBX it works fine but if i use 1079 it doesn't work

hope · Post by **hope** » Fri Jul 25, 2008 9:52 am

did you try to set port 1079 after SIP server address at phone side, like sip_server_ip:1079

Javedcse · Post by **Javedcse** » Fri Jul 25, 2008 8:48 pm

Yup i tried with it. But doesnt work.

peng · Post by **peng** » Sun Jul 27, 2008 5:47 pm

How do the REGISTRATION packets and the response packets look like?
Can you try capturing the packets and past them here?

Javedcse · Post by **Javedcse** » Mon Jul 28, 2008 3:28 am

what do you mean by the REGISTRATION packets and the response packets ?

taitan · Post by **taitan** » Mon Jul 28, 2008 10:24 am

hi

did you put 1079 in [Local Port] setting at Brekeke SIP Server?
(Configuration -> SIP -> SIP exchanger )

hope · Post by **hope** » Mon Jul 28, 2008 10:33 am

Use some tool to monitor the SIP packets
http://www.brekeke-sip.com/wiki/index.p ... i=f4b972a2

did you change SIP port from brekeke sip server/configuration/SIP/ local port? or you also change something else?

What is "another sip server which is using sip port 5060" when you registered phone to sip port 1079?

Javedcse · Post by **Javedcse** » Mon Jul 28, 2008 9:30 pm

@Hope

I've changed sip port to 1079 from sip server/configuration/SIP/ local port.

The another sip server which is using sip port 5060 is Cordia. It's a private Sip server.
Someone have idea on it?

hope · Post by **hope** » Tue Jul 29, 2008 10:07 am

if you turn off the other SIP server(Cordia), can you register the phone to brekeke pbx with port 1079?

Javedcse · Post by **Javedcse** » Tue Jul 29, 2008 9:32 pm

Ya I can register with Brekeke using sip port 1079 if i don't use Cordia.

I think i need to set a dialplan for that.