Brekeke and 3CX Connection

Discuss any topic about Brekeke PBX.

Moderator: Brekeke Support Team

Post Reply
syntax1269
Posts: 16
Joined: Sun Nov 18, 2007 7:49 pm

Brekeke and 3CX Connection

Post by syntax1269 »

1. Brekeke Product Name and version:
Brekeke SIP Server for Brekeke PBX, Version 2.1.6.6

2. Java version:
1.5.0_14

3. OS type and the version:
Windows 2003 R2

4. UA (phone), gateway or other hardware/software involved:
3CX

5. Select your network pattern from http://www.brekeke-sip.com/bbs/network/ ... terns.html :
Pattern 9

6. Your problem:
I am tring to connect 3CX to Brekeke PBX.
UA connected to 3CX and using Brekeke to make the final termination to land/cell number.

what is happening is that the call goes as far as ring and when answerd the call drops.
james
Posts: 501
Joined: Mon Dec 10, 2007 12:56 pm

Post by james »

Hi,
Which audio codec did you use?
Can you see any error message at [Active Sessions] page?
syntax1269
Posts: 16
Joined: Sun Nov 18, 2007 7:49 pm

Post by syntax1269 »

James,

i am using uLaw.
I onle see the STUN error, and i tried to disable this, but the error jsut keeps coming up.

this is what i am getting on the status page

14:11:07.092 StratLink::onHangUp [CM104001] Call(23): Ext.10003 hung up call; cause: unknown
14:10:35.061 CallLegImpl::onConnected [CM103001] Call(23): Created audio channel for Ln:10001@DataWorld (209.208.XXX.XXX:10016) with Media Server (138.210.XXX.XXX:9032)
14:10:35.045 StratInOut::onConnected [CM104005] Call(23): Setup completed for call from Ext.10003 to Ln:10001@DataWorld
14:10:35.045 CallLegImpl::onConnected [CM103001] Call(23): Created audio channel for Ext.10003 (192.168.2.108:42750) with Media Server (138.210.XXX.XXX:7044)
14:10:34.045 MediaServerReporting::STUN [MS101003] Call(23) Ln:10001@DataWorld: Possible firewall problem. Address mapping failed on STUN server 138.210.XXX.XXX:3478 for local address ":9032"
14:10:33.873 CallConf::onIncoming [CM103002] Call(23): Incoming call from 10003 (Ext.10003) to sip:9800@138.210.XXX.XXX
peng
Posts: 110
Joined: Wed Jul 20, 2005 7:06 pm

Post by peng »

Can you capture the packets using WireShark?
Post Reply