how to implement the SIP Server to be firewall traversal

amr_elsawi · Post by **amr_elsawi** » Sat Oct 27, 2007 2:51 am

Dear all

Do any one can give an Idea about how to make our SIP Server to be firewall traversal , because some of our users can send but not receive the calls.

How we can solve this problem?

Thank you
Best Regards
Amr

voipwell.com · Post by **voipwell.com** » Sat Oct 27, 2007 2:22 pm

First, you must have rtp relay on for the sip server and check a conversation to make sure it is working. I assume the sip server is not behind a firewall and the users are right?

Nick

amr_elsawi · Post by **amr_elsawi** » Sun Oct 28, 2007 7:48 am

Dear Nick

My Sip server not behind firewall, I need the system to support firewall traversal to be able for the clients all over the world to call through my Server in two ways.

Thank you
Amr

peng · Post by **peng** » Mon Oct 29, 2007 1:58 pm

Dipends on the firewall settings, it is impossible to reach packets to clients.

Usually you better set [Keep address/port mapping] = on and [Interval] = 12000 (or less ) at Configuration page.

amr_elsawi · Post by **amr_elsawi** » Wed Oct 31, 2007 1:34 am

Dear Sir

it's already like that, but still some users can call in one direction only( can call out, but can not receive calls), so there is any additional configuration for this situation.

Thank you

peng · Post by **peng** » Wed Oct 31, 2007 6:39 pm

If sipphones have NAT traversal functions,
can you set it off?