Authentication by IP only please help us.

Willtsuru · Post by **Willtsuru** » Thu Sep 13, 2007 10:06 am

1. Brekeke Product Name and version: PBX 2.0

2. Java version:1.5_11

3. OS type and the version:

4. UA (phone), gateway or other hardware/software involved:
X-Lite BT100
5. Select your network pattern from http://www.brekeke-sip.com/bbs/network/ ... terns.html :

6. Your problem:Please can you help us? Our problem is that our new termination service make authentication only by IP and dont use any username and Passowrd.Then how can we configure the ARS to register our PBX in this provider?This is a very important point to us.please help us.Thanks in advance fo any help.

peng · Post by **peng** » Thu Sep 13, 2007 10:57 pm

> our new termination service make authentication only by IP

what is this? Can you give me the information?

And what does "by IP" means ?

Willtsuru · Post by **Willtsuru** » Fri Sep 14, 2007 1:17 am

Hi peng.
This is mean that we dony receive any username and password to confogire the ARS.Our tsystem is authenticated only by our IP address.When we try to use this termination service our call is allowed or not if come from an IP registered in the termination provider gateway.

Thanks.

voipwell.com · Post by **voipwell.com** » Fri Sep 14, 2007 4:25 pm

Hello,

This is still handled by ARS. If you are using ip authentication then don't put anything in the username and password field of the ARS. Everything else is the same below that.