Gateway with ARS

[loco_tdg]

Hi! One more question. How can i do in order to make a route with ARS, this route when you digit 9 followed by some digits take a pstn line in a gate, i need the command or the way to do that, i made that like the manual says but it does not work. Thanks

[voipwell.com]

The example I referred you to uses a 2 as a prefix, replace that with a 9. Of course in the example the ip addresses are examples, you must replace them with your actual ip addresses.

Nick

[loco_tdg]

hi i sow the example with the sipura, but i´m not working with linksys, i want to know how to set this at ARS, Im working with a Gate 104 from Tigernetcom

[voipwell.com]

Why do you think the ARS would be different for the Gate104. If the Gate104 has 1 stage dialing it should work. I have a gate104 but never tried 1 state dialing. Have you tried it with the spa-3000 ars example?

[loco_tdg]

That gate is two stage dialing. I tried with the example of the manual, but it does not work. Help me!!!

[voipwell.com]

If it's two stage dialing then the best you can do is dial that device's extension, hear the dial tone of the pstn then dial the number.

[loco_tdg]

Hi, I can make a call dialing the extension of that gate then calling some number, but my problem is that i have 15 gates and sometimes some of them are busy and i have to verifier which of them are not busy and i need to buy 5 more gates.

[voipwell.com]

Well, that's not really a problem.

Let's say you have gates with user id's of 1-20. When someone wants to call they always dial 1 to get the first gate.

You set up a call hunting by going to user 1's screen and put in user 2 as the busy call forward number. Go to user 2 and put in 3 as the busy call forward. Go to user 3 and put in user 4 as the busy call forward all the way up to 20 and it will work fine. Brekeke can do anything(except shared call line appearance).