Author |
Message |
cinoaz Brekeke Newbie
Joined: 20 Sep 2011 Posts: 2
|
Posted: Tue Sep 20, 2011 10:46 am Post subject: T1, T2 and T4 Timers |
|
|
1. Brekeke Product Name and version:
2.4.8.6/286.3
6. Your problem:
I believe I read Brekeke SIP sets T2 and T4 timers based on T1, but I don't see where I can change T1 value?
How do I change the default value for T1? |
|
Back to top |
|
Harold Brekeke Master Guru
Joined: 21 Sep 2008 Posts: 289
Location: Japan
|
Posted: Tue Sep 20, 2011 5:34 pm Post subject: |
|
|
Set the "net.sip.timer.t1" in the [Configuration] > [Advanced] page.
For example:
-------------------
net.sip.timer.t1 = 600
-------------------
Its default value is 500 (ms).
What kind of timer do you want to tune actually? |
|
Back to top |
|
cinoaz Brekeke Newbie
Joined: 20 Sep 2011 Posts: 2
|
Posted: Tue Sep 20, 2011 6:33 pm Post subject: |
|
|
It's the INVITE I need to slow down. Our simulation has quite a bit of transport delay that we need to reproduce, however, Brekeke SIP keeps resending too quicky and often which makes troubleshooting difficult.
I needed a way to change the T1 timer to slow down the retry rates of T1, and subsequently T2 and T4, since T2 and T4 I think are values based off of T1. |
|
Back to top |
|
Harold Brekeke Master Guru
Joined: 21 Sep 2008 Posts: 289
Location: Japan
|
Posted: Tue Sep 20, 2011 11:57 pm Post subject: |
|
|
I suppose the "net.sip.timer.t1" will meet your requirement.
If you use &net.sip.timer.t1 in the DeployPattern, you can define it in a certain route. |
|
Back to top |
|
|