|
|
Author |
Message |
noci Brekeke Member
Joined: 05 Jan 2011 Posts: 16
Location: Netherlands
|
Posted: Wed Jan 05, 2011 4:31 pm Post subject: Follow Me... well, follow a number... |
|
|
1. Brekeke Product Name and version:
PBX, 2.4.7.3
2. Java version:
Java 1.6.0.19
3. OS type and the version:
Linux CentOS 5.1
4. UA (phone), gateway or other hardware/software involved:
various
5. Select your network pattern from http://www.brekeke-sip.com/bbs/network/networkpatterns.html :
patern11, Brekeke runs ON the firewall.
6. Your problem:
There is no real Follow me (AFAICT).
With follow me I don't mean the solution that is mentioned elsewhere of adding (+enabling/disable) a forward.
Also a switch cannot be used because numbers where to follow to are not predictable. (cafetaria like office).
The first option should is almost it. It should have some way to add/remove/replace a number (not disable) and enable/add it.
Alternatively this probable could be built if the ivr-api also has a setUserProperty along the getUserProperty.
Request: is it possible to add a way to update User Properties.
Or : provide in a real follow me: with enable (= add follow me, 1 number only)
disable (remove the number) or
change to a different phone. |
|
Back to top |
|
hope Brekeke Master Guru
Joined: 15 Jan 2008 Posts: 862
|
|
Back to top |
|
noci Brekeke Member
Joined: 05 Jan 2011 Posts: 16
Location: Netherlands
|
Posted: Fri Jan 07, 2011 1:52 pm Post subject: |
|
|
That assumes that webaccess is available. If someone sits at a desk with an ordinary numbers only phone, or a mobile (not being a smart-phone) that will be a challenge.
Unless I can access the webservice from within the IVR scripting engine that might become quite a challenge.
It will be a plunge, not being familiar with java, soap and brekeke.
Do you have any advise on helpfull information?
[Edit]
Some further investigation..
For SOAP the Axis product is mentioned. And a reference exists to V1.2 (probably meant for an older Java v1.4)
We have Java V1.6.0.19 in use. + Tomcat 7.0.2
Can i just install Axis V1.2, or do I need that last in that range V1.4
Or is AXIS2 required.
This currently is provoking more questions than answer (based on the supplied documentation).
[Edit2]
The correct URL for axis2 is:
http://axis.apache.org/axis2/java/core/
Last edited by noci on Fri Jan 07, 2011 2:42 pm; edited 1 time in total |
|
Back to top |
|
|
|
|
|